Hychem HY-GROUT E270

2 component, non-shrink epoxy grout with an extended pot-life & low exotherm

Product Description

Hychem HY-GROUT E270 is designed for use wherever high ambient temperatures preclude the use of general purpose epoxy or cement based construction grouts. This may be due to large pour volume, high ambient temperature during application or high temperatures in the working environment. Hychem HY-GROUT E270 is formulated to provide good flow properties in tight spaces. Additional quartz aggregate may be added where design considerations allow the use of a heavier bodied grout.

View Technical Data Sheet (TDS)

Safety Data Sheets (SDS)

Safety Data Sheet (SDS) – Part A Safety Data Sheet (SDS) – Part B

Typical Applications

Grouting bolts, rebar, dowels and inserts in concrete, rock and brickwork
Grouting holding down bolts for dynamic machinery such as turbines, motors, winches, pumps and conveyors
Grouting crane and transporter rails
Grouting of machinery base plates
Grouting column base plates in corrosive environments
Bonding new to old concrete
As a high strength repair mortar for concrete structures
As a general replacement for cement grouts where environmental conditions prevent their use

Features

Non-Shrink
Suitable for installation from 5mm to 75mm as supplied or 5mm to 100mm+ with the addition of suitable aggregates. Consult Hychem for technical advice
Dust free application, no need for addition of 3rd component filler pack
Rapid development of strength with good pot life and relatively low exotherm
Very high mechanical strength – compressive, tensile and flexural
Excellent vibration and dynamic load tolerance
Excellent flow, suited to tight clearances of 5 to 15 mm
Resistant to a wide range of chemicals, acids, caustic and hydrocarbons
Moisture tolerant, can be applied to damp concrete

Expert structural solutions and support for your next project:

Contact